Home › Engine / Hybrid System › M20A-FKS (COOLING) › THERMOSTAT › from 2021.02
RM33A0E _51 Engine / Hybrid System _098633 M20A-FKS COOLING _0461855 THERMOSTAT A

M20A-FKS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16032 1.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

Hide 16031 2.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A435074

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


b.
A402018

Remove the gasket from the water inlet with thermostat sub-assembly.