Home › Engine / Hybrid System › M20A-FKS (COOLING) › WATER PUMP › from 2021.02
RM33A0E _51 Engine / Hybrid System _098633 M20A-FKS COOLING _0461854 WATER PUMP A

M20A-FKS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16572D 3.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16032 4.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A402015

Disconnect the water inlet with thermostat sub-assembly connector.


b.
A402016

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.



HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.



c.
A435070

Disconnect the sensor wire connector.


d.
A435071

Disconnect the engine water pump assembly (water inlet housing) connector.


e.
A435072

Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).


f.
A435073

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.


g.
A435074

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


h.
A402018

Remove the gasket from the water inlet with thermostat sub-assembly.


i.
A402026

Remove the gasket from the engine water pump assembly (water inlet housing).


j.

Using an E8 "TORX" socket wrench, remove the stud bolt.