Home › Drivetrain › K120 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461913 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM J

K120 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  ECU Power Source Circuit  


DESCRIPTION

When the ignition switch is turned to ON, the battery voltage is applied to terminal MREL of the ECM through the coil of the EFI-MAIN NO. 1 relay. This causes the EFI-MAIN NO. 1 relay to close, which supplies power to terminal +B of the TCM.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

Perform registration and/or initialization when parts related to the continuously variable transaxle system are replaced.

Click hereDrivetrain>K120 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>PRECAUTION



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)
a.

Disconnect the C111 TCM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C111-2 (E1) - Body ground Always Below 1 Ω



c.

Connect the C111 TCM connector.


Result:
Proceed to
OK
NG



OK

2.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL)
a.

Disconnect the C111 TCM connector.


b.

Turn the ignition switch to ON.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
C111-1 (+B) - Body ground Ignition switch ON 11 to 14 V



d.

Connect the C111 TCM connector.


Result:
Proceed to
OK
NG



OK

NG

3.CHECK HARNESS AND CONNECTOR (TCM - EFI-MAIN NO. 1 RELAY)
3.CHECK HARNESS AND CONNECTOR (TCM - EFI-MAIN NO. 1 RELAY)
a.

Remove the EFI-MAIN NO. 1 relay from the engine room relay block and junction block assembly.


b.

Disconnect the C111 TCM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C111-1 (+B) - 5 (EFI-MAIN NO. 1 relay) Always Below 1 Ω
C111-1 (+B) or 5 (EFI-MAIN NO. 1 relay) - Body ground Always 10 kΩ or higher



d.

Connect the C111 TCM connector.


e.

Install the EFI-MAIN NO. 1 relay to the engine room relay block and junction block assembly.


Result:
Proceed to
OK
NG



OK

GO TO ECM POWER SOURCE CIRCUIT (ENGINE CONTROL SYSTEM / SFI SYSTEM)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR