Home › General › MAINTENANCE › M20A-FKS SPARK PLUG › from 2021.02
RM33A0E _V1 General _065356 MAINTENANCE _0462092 M20A-FKS SPARK PLUG A

MAINTENANCE  M20A-FKS SPARK PLUG  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

HINT:

Perform "Inspection After Repair" after replacing a spark plug.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install the 4 spark plugs to the cylinder head sub-assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If a spark plug has been struck or dropped, replace it.



Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION