Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG › from 2021.02
RM33A0E _51 Engine / Hybrid System _098626 M20A-FKS ENGINE CONTROL _0462107 IGNITION COIL AND SPARK PLUG A

M20A-FKS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

Hide 19500 2.INSTALL IGNITION COIL ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Using an 8 mm socket wrench, install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.



b.

Connect the 4 ignition coil assembly connectors.


Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION