Home › Engine / Hybrid System › M20A-FKS (STARTING) › STARTER (for DENSO Made) › from 2021.02
RM33A0E _51 Engine / Hybrid System _098630 M20A-FKS STARTING _0462224 STARTER(for DENSO Made) A

M20A-FKS STARTING  STARTER(for DENSO Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 11363A 4.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A484054

Disengage the claw as shown in the illustration to remove the flywheel housing side cover.


Hide 28100 5.REMOVE STARTER ASSEMBLY

a.
A484056

Disconnect the starter assembly connector.


b.

Open the terminal cap.


c.
A484058

Remove the nut and disconnect the No. 2 engine wire from terminal 30.


d.
A484060

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.