Home › Engine / Hybrid System › M20A-FKS (STARTING) › STARTER (for VALEO Made) › from 2021.02
RM33A0E _51 Engine / Hybrid System _098630 M20A-FKS STARTING _0462228 STARTER(for VALEO Made) A

M20A-FKS STARTING  STARTER(for VALEO Made)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the No. 2 engine wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter assembly connector.


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A484063

Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.

NOTICE:
·

Make sure the claw makes a click sound, indicating that it fits tightly.

·

Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.




Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL