44777
1.INSTALL NO. 1 VACUUM HOSE CONNECTOR (for M20A-FKS, A25A-FKS)
Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.
Check that there is no foreign matter on the connecting parts.
After connecting the No. 1 vacuum hose connector, check that the vacuum pump assembly and No. 1 vacuum hose connector are securely connected by pulling on them.
Connect the vacuum hose to the No. 1 vacuum hose connector.
44773F
2.INSTALL UNION TO CHECK VALVE HOSE (for M20A-FKS)
Install the 2 clips to the union to check valve hose.
| *a | Paint Mark |
Connect the union to check valve hose to the No. 1 vacuum hose connector and slide the clip to secure it.
When connecting the union to check valve hose, face the paint mark up.
Make sure that the tabs of the clip are facing the back of the vehicle.
Engage the clamp to install the union to check valve hose.
| *a | Paint Mark |
Connect the union to check valve hose to the brake booster assembly and slide the clip to secure it.
When connecting the union to check valve hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
44773F
3.INSTALL UNION TO CHECK VALVE HOSE (for A25A-FKS)
Install the 2 clips to the union to check valve hose.
| *a | Paint Mark |
Connect the union to check valve hose to the No. 1 vacuum hose connector and slide the clip to secure it.
When connecting the union to check valve hose, face the paint mark up.
Make sure that the tabs of the clip is facing the back of the vehicle.
| *a | Paint Mark |
Connect the union to check valve hose to the brake booster assembly and slide the clip to secure it.
When connecting the union to check valve hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
17361M
4.INSTALL AIR TUBE (for 2GR-FKS)
Engage the clamp to install the air delivery way to the intake air surge tank assembly.
Install the 2 clips to the air tube.
| *a | Paint Mark |
Connect the air tube to the air delivery way and slide the clip to secure it.
Make sure to position the paint mark of the air tube as shown in the illustration.
Make sure that the tabs of the clip are aligned as shown in the illustration.
| *a | Paint Mark |
| *b | Dot Paint |
Connect the air tube to the vacuum pump assembly and slide the clip to secure it.
Make sure to position the paint mark of the air tube as shown in the illustration.
Make sure that the tabs of the clip are aligned as shown in the illustration.
Connect the 2 vacuum transmitting hose assemblies to the air delivery way.
44773F
5.INSTALL UNION TO CHECK VALVE HOSE (for 2GR-FKS)
Install the 2 clips to the union to check valve hose.
| *a | Paint Mark |
Connect the union to check valve hose to the air delivery way and slide the clip to secure it.
When connecting the union to check valve hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
| *a | Paint Mark |
Connect the union to check valve hose to the brake booster assembly and slide the clip to secure it.
When connecting the union to check valve hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
Engage the clamp to install the union to check valve hose to the air tube.
53607A
6.INSTALL FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY (for 2GR-FKS)
55708
7.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for 2GR-FKS)