Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › from 2021.02
RM33A0E _54 Brake _065365 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0319124 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace the front axle hub sub-assembly.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53876A 3.SEPARATE FRONT FENDER LINER

C372694C01
0.917,4.073 0.917,3.875 false 0.854,4.073 1.167,4.229 0.313,0.156 10 false *a
*a Protective Tape


a.

Remove the screw and 6 clips.


b.

Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to separate the front fender liner.


Hide 89543 4.REMOVE FRONT SPEED SENSOR

a.

Turn back the front fender liner.


b.
C372695

Disconnect the front speed sensor connector.


c.

Disengage the clamp.


d.
C372696

Remove the bolt and separate the sensor clamp.


e.
C372697

Remove the bolt and separate the front flexible hose and sensor clamp.


f.
C372698

Disengage the clamp to separate the sensor clamp.


g.

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Keep the tip of the front speed sensor and installation hole free of foreign matter.

·

Do not rotate or apply excessive force to the front speed sensor when removing it from the steering knuckle. Rotating or applying excessive force may result in damage to the front speed sensor.