Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › from 2021.02
RM33A0E _54 Brake _065366 BRAKE SYSTEM (OTHER) _0319131 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28800 2.REMOVE BATTERY

Hide 3.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 4.DISCONNECT BRAKE LINE

a.
C454620

Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.

NOTICE:
·

Do not damage or deform the brake lines.

·

Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.




Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 84340 6.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 47264A 7.REMOVE PUSH ROD PIN

a.
C372720

Remove the clip and push rod pin.


Hide 8.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C372721

Disengage the clamp to separate the wire harness from the brake pedal support assembly.


b.
C372722

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C372723C01
0,0 0,0 false
V100135

Nut
V100136

Clip


Remove the 2 clips.


d.

Remove the 4 nuts and push the brake booster assembly toward the engine compartment.

NOTICE:
·

Do not apply excessive force to the brake lines.

·

Do not apply excessive force to the wire harness.




e.

Remove the brake pedal support assembly while avoiding the stud bolts of the brake booster assembly and brake booster support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



Hide 47101A 9.REMOVE BRAKE PEDAL RETURN SPRING

a.
C372724

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 84345 10.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
C380331

Disengage the 2 claws and remove the stop light switch mounting adjuster.


Hide 47121 11.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.