Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
67913
3.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
88707
6.SEPARATE SUCTION PIPE SUB-ASSEMBLY
Disengage the clamp to separate the suction pipe sub-assembly from the brake tube clamp bracket.
Do not deform the refrigerant lines.
Do not damage the clamp.
Disengage the clamp to separate the suction pipe sub-assembly from the engine mounting insulator sub-assembly RH.
Do not deform the refrigerant lines.
Do not damage the clamp.
Remove the bolt and rotate the hook connector as shown in the illustration.
Disconnect the suction pipe sub-assembly from the air conditioning unit assembly.
Remove the O-ring from the suction pipe sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88710E
7.SEPARATE AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
Disconnect the connector from the air conditioner tube and accessory assembly.
Disengage the clamp to separate the air conditioner tube and accessory assembly.
Do not deform the refrigerant lines.
Do not damage the clamp.
Disconnect the air conditioner tube and accessory assembly from the air conditioning unit assembly.
Remove the O-ring from the air conditioner tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
44772
8.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE
Slide the clip and disconnect the check valve to connector tube hose from the brake booster assembly.
44763A
9.SEPARATE NO. 1 HOSE TO HOSE TUBE
Remove the 2 nuts and separate the No. 1 hose to hose tube.
10.LOOSEN LOCK NUT
| *1 | Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
Loosen the lock nut of the brake master cylinder push rod clevis.
47264A
11.REMOVE PUSH ROD PIN
12.SEPARATE BRAKE LINE
Remove the bolt and separate the front brake tube way from the vehicle body.
Disengage the clamp and separate the No. 2 brake tube clamp from the vehicle body.
Do not kink or damage the brake lines.
Disengage the 3 clamps to remove the No. 2 brake tube clamp from the brake lines.
Do not kink or damage the brake lines.
44610
13.REMOVE BRAKE BOOSTER ASSEMBLY
Disconnect the connector from the vacuum warning switch assembly.
Remove the 4 nuts and push the brake booster assembly toward the engine compartment.
Do not apply excessive force to the brake lines or refrigerant lines.
Remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.
Remove the brake booster assembly from the vehicle body.
Do not apply excessive force to the brake lines or refrigerant lines.
44785
14.REMOVE BRAKE BOOSTER GASKET