The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
87130D
1.REMOVE BLOWER ASSEMBLY
82210K
2.REMOVE AIR CONDITIONING HARNESS ASSEMBLY
87050C
3.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87050E
4.REMOVE NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for 3 Zone Type)
88897M
5.REMOVE HEATER PIPE GROMMET
87124B
6.REMOVE HEATER CLAMP
87107A
7.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88899L
8.REMOVE GROMMET SUB-ASSEMBLY
88515
9.REMOVE COOLER EXPANSION VALVE
88501
10.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88625
11.REMOVE NO. 1 COOLER THERMISTOR
Remove the No. 1 cooler thermistor.