Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Parking Support Brake System) › from 2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0462611 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E454345E03
0.135,0.448 1.698,0.75 1.563,0.302 10 false from IG1-NO. 1 Relay 3.167,0.646 4.24,0.885 1.073,0.24 10 false ECU-IG1 NO. 4 5.365,1.927 6.594,2.427 1.229,0.5 10 false Clearance Warning ECU Assembly 5.583,0.479 5.896,0.677 0.313,0.198 10 false IG 5.573,1.271 5.885,1.469 0.313,0.198 10 false E 5.281,1.135 5.594,1.333 0.313,0.198 10 false 31 5.354,0.354 5.667,0.552 0.313,0.198 10 false 1 5.375,1.76 5.688,1.958 0.313,0.198 10 false R39

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)
a.

Disconnect the R39 clearance warning ECU assembly connector.


E409691C10
1.448,0.406 1.948,0.656 0.5,0.25 2.438,1.156 2.833,0.917 true 0.167,0.083 0.417,0.25 0.25,0.167 10 false *a 1.573,0.458 1.927,0.698 0.354,0.24 10 false R39 2.896,0.844 3.125,1.042 0.229,0.198 10 false IG
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
R39-1 (IG) - Body ground Ignition switch ON 11 to 14 V
R39-1 (IG) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R39-31 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR