Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Parking Support Brake System) › from 2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0462611 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System) T

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System)  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

When an open circuit or frozen indication is displayed by the self-check function, check for DTCs and troubleshoot according to each inspection procedure.



General
Symptom Suspected Area Link
System does not operate at all Proceed to "Clearance Warning ECU Power Source Circuit" Click here
Check that the CAN communication system is operating normally Click here
Check that the Meter / gauge system is operating normally -
Clearance warning ECU assembly Click here
System cannot be turned off Check that the CAN communication system is operating normally Click here
Check that the Meter / gauge system is operating normally -
Steering pad switch assembly Click here
Spiral cable sub-assembly Click here
Clearance warning ECU assembly Click here

Sonar Function
Symptom Suspected Area Link
Frozen indication is displayed in self-check function Proceed to "Sensor Frozen Indication (Dirty or Frozen)" Click here
Combination meter assembly (shift selection) operates normally, but detection operates when shift lever is in P, or detection does not operate when shift lever is in any position other than P (front sonar) Check that the CAN communication system is operating normally Click here
Clearance warning ECU assembly Click here
Combination meter assembly (shift selection) operates normally, but detection operates when shift lever is not in R, or does not operate with shift lever in R (rear sonar) Check that the CAN communication system is operating normally Click here
Clearance warning ECU assembly Click here
Combination meter assembly (speedometer) operates normally, but detection does not operate when vehicle speed meets operation condition, or detection operates when vehicle speed does not meet operation condition (front sonar) Check that the CAN communication system is operating normally Click here
Clearance warning ECU assembly Click here

Buzzer Function
Symptom Suspected Area Link
Sonar detection operation is normal but buzzer operation is intermittent Check that the temporary mute function is not operating -
Proceed to "No. 1 Clearance Warning Buzzer Circuit" Click here
Clearance warning ECU assembly Click here

Display Function
Symptom Suspected Area Link
Detection operation is normal but clearance sonar indicator does not illuminate Check that the CAN communication system is operating normally Click here
Combination meter assembly (LED): Perform Active Test (Indicat. Clearance Sonar LCD) Click here
Combination meter assembly Click here
Clearance warning ECU assembly Click here
Detection operation is normal but all displays do not appear Check that the CAN communication system is operating normally Click here
Clearance warning ECU assembly Click here
Detection operation is normal but sonar displays do not appear on the multi-information display Check that the CAN communication system is operating normally Click here
Combination meter assembly Click here
Clearance warning ECU assembly Click here
Detection operation is normal but sonar displays do not appear on the radio and display receiver assembly Check that the CAN communication system is operating normally Click here
Radio and display receiver assembly Click here
Rear television camera assembly Click here
Television camera controller*2 Click here
Clearance warning ECU assembly Click here
Detection operation is normal but sonar displays do not appear on the on the headup display*1 Check that the CAN communication system is operating normally Click here
Meter mirror sub-assembly Click here
Clearance warning ECU assembly Click here

*1: w/ Headup Display System

*2: w/ Panoramic View Monitor System