28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
Connect the No. 2 engine wire to terminal 30 with the nut.
Close the terminal cap.
Connect the starter assembly connector.
11363A
2.INSTALL FLYWHEEL HOUSING SIDE COVER
Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
Make sure the claw makes a click sound, indicating that it fits tightly.
Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
12361A
3.INSTALL FRONT ENGINE MOUNTING INSULATOR
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL