The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If an airbag deploys for any reason, it may cause a serious injury.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
73350C
3.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
4.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
5.REMOVE REAR SEAT CUSHION LOCK HOOK
6.REMOVE REAR SEATBACK ASSEMBLY LH
62332A
7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
8.REMOVE REAR SIDE SEATBACK ASSEMBLY LH
62331A
9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
10.REMOVE REAR SIDE SEATBACK ASSEMBLY RH
Use the same procedure as for the LH side.
81006
11.REMOVE CENTER STOP LIGHT SET
73370E
12.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
73360D
13.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62472A
14.REMOVE INNER ROOF SIDE GARNISH LH
62471A
15.REMOVE INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
73373F
16.REMOVE REAR SEAT SHOULDER BELT HOLE COVER
64330
17.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
64330
18.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
64272B
19.REMOVE ROOM PARTITION BOARD LH
89571
20.REMOVE FUEL PUMP CONTROL ECU
Disconnect the 2 fuel pump control ECU connectors.
Remove the nut and fuel pump control ECU from the vehicle body.
Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.
89573
21.REMOVE FUEL PUMP CONTROL ECU BRACKET
Remove the 2 bolts and fuel pump control ECU bracket from the fuel pump control ECU.