Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Fold Down Seat Type) › from 2021.02
RM33A0E _58 Vehicle Interior _065385 SEAT _0327858 REAR SEAT ASSEMBLY(for Fold Down Seat Type) A

SEAT  REAR SEAT ASSEMBLY(for Fold Down Seat Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

Hide 1. PRECAUTION (w/ Rear Seat Side Airbag)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag)

for A25A-FKS:

Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL

for 2GR-FKS:

Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL

for M20A-FKS:

Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>REMOVAL

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If an airbag deploys for any reason, it may cause a serious injury.



Hide 73350C 3.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

a.
B491651C01
2.74,0.948 2.906,1.167 false 2.969,1.094 3.219,1.333 0.25,0.24 10 false *a
*a Protective Tape
V113146

Insert Screwdriver Here
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disconnect the rear center seat outer belt assembly as shown in the illustration.


Hide 4.REMOVE REAR SEAT HEADREST ASSEMBLY LH (w/ Removable Headrest)

a.

Remove the rear seat headrest assembly LH.


Hide 5.REMOVE REAR SEAT HEADREST ASSEMBLY RH (w/ Removable Headrest)

a.

Remove the rear seat headrest assembly RH.


Hide 6.REMOVE REAR SEAT CUSHION ASSEMBLY

a.
B470024C01
2.417,0.708 2.604,0.563 true 1.219,0.51 1.479,0.396 true 0.531,1.542 0.688,1.344 true 2.385,2.021 2.198,1.75 true 0.292,1.479 0.521,1.656 0.229,0.177 10 true *a 2.625,0.448 2.833,0.615 0.208,0.167 10 true *b 1.521,0.313 1.729,0.479 0.208,0.167 10 true *b 2.448,1.99 2.677,2.167 0.229,0.177 10 true *a 0.906,2.646 1.135,2.865 0.229,0.219 10 false A 1.917,2.75 2.146,2.969 0.229,0.219 10 false A
*a Rear Seat Cushion Frame Hook (Front Side)
*b Rear Seat Cushion Frame Hook (Rear Side)
V113146

Place Hand Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Lift the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the rear seat cushion lock hooks.

NOTICE:

Be sure to hold the parts of the rear seat cushion assembly directly next to the rear seat cushion frame hooks when lifting it. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.


Standard Measurement:
Area Measurement
A 245 mm (9.64 in.)



b.

Disengage the 2 rear seat cushion frame hooks on the rear side of the rear seat cushion assembly as shown in the illustration and remove the rear seat cushion assembly.

NOTICE:

Be careful not to damage the vehicle body.



c.

w/ Seat Heater System:

i.

Disconnect each connector.


ii.

Disengage each clamp.



Hide 72693 7.REMOVE REAR SEAT CUSHION LOCK HOOK

a.
B470026C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



Hide 8.REMOVE REAR SEATBACK ASSEMBLY LH

a.

Fold the rear seatback assembly LH forward.


b.
B472275C01
2.292,0.74 2.635,0.635 true 2.667,0.521 2.865,0.708 0.198,0.188 10 true *a
*a Fastener


Disengage the fastener.


c.
B472318

Remove the 2 bolts.


d.

Disengage the 2 guides and remove the rear seatback assembly LH.

NOTICE:

Be careful not to damage the vehicle body.



e.

w/ Seat Heater System:

i.

Disengage the clamp.



Hide 9.REMOVE REAR SEATBACK ASSEMBLY RH

a.

Fold the rear seatback assembly RH forward.


b.
B472276C01
0.844,1.094 0.531,0.875 true 0.271,0.75 0.49,0.938 0.219,0.188 10 true *a
*a Fastener


Disengage the fastener.


c.
B472319

Remove the 2 bolts.


d.

Disengage the 2 guides and remove the rear seatback assembly RH.

NOTICE:

Be careful not to damage the vehicle body.



e.

w/ Seat Heater System:

i.

Disengage the clamp.



Hide 62332A 10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Disconnect the rear door opening trim weatherstrip LH.


Hide 11.REMOVE REAR SIDE SEATBACK ASSEMBLY LH

a.

Disconnect the rear seat outer belt LH from the rear seat shoulder belt guide LH.


b.

w/ Rear Seat Side Airbag:

i.

Disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


1.
B474821C04
1.75,1.083 2.333,1.083 true 1.948,1.385 2.531,1.385 false 1.052,1.417 1.635,1.417 true 2.375,0.99 2.688,1.146 0.313,0.156 10 false *a 2.563,1.313 2.875,1.469 0.313,0.156 10 false *b 0.927,1.333 1.104,1.521 0.177,0.188 10 false A
*a White Housing Lock
*b Yellow CPA
V113147

Slide in this Direction


Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

2.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.





c.
B491319

Remove the bolt.


d.

Disengage the hook and remove the rear side seatback assembly LH.

NOTICE:

Be careful not to damage the vehicle body.



Hide 62331A 12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 13.REMOVE REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.