Home › Engine / Hybrid System › M20A-FKS (EMISSION CONTROL) › EGR VALVE › from 2021.02
RM33A0E _51 Engine / Hybrid System _098629 M20A-FKS EMISSION CONTROL _0463332 EGR VALVE A

M20A-FKS EMISSION CONTROL  EGR VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
·

Replacement of EGR valve assembly

·

Gas leaks from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PROCEDURE

Hide 25680 1.REMOVE EGR COOLER ASSEMBLY

Hide 25601 2.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

a.
A433451

Disconnect the EGR valve assembly connector.


b.
A427802

Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.


c.
A427803

Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.


d.
A427804

Remove the EGR inlet gasket from the intake manifold.


Hide 25620 3.REMOVE EGR VALVE ASSEMBLY

a.
A433449C01
1.5,0.146 1.646,0.146 1.646,0.146 1.76,0.302 true 1.26,1.448 1.563,1.448 true 1.323,0.063 1.552,0.25 0.229,0.188 10 true *1 1.083,1.365 1.292,1.552 0.208,0.188 10 true *2
*1 No. 4 Water By-pass Hose
*2 No. 8 Water By-pass Hose


Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly.


b.

Slide the clip and disconnect the No. 8 water by-pass hose from the EGR valve assembly.


c.
A427806

Using an 8 mm socket wrench, remove the 2 bolts and EGR valve assembly.