Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0463554 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U030051  Internal Control Module Software Incompatibility Not Programmed  U030057  Internal Control Module Software Incompatibility Invalid/Incompatible Software Component  


DESCRIPTION

·

If the forward recognition camera cannot verify the vehicle information sent from the ECM, the forward recognition camera stores DTC U030051.

·

If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the ECM, the forward recognition camera stores DTC U030057.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U030051 Internal Control Module Software Incompatibility Not Programmed When the ignition switch is ON for 3 seconds, the vehicle information sent from the ECM cannot be verified by the forward recognition camera for approximately 3 seconds or more. Pre-collision system Radar Cruise2
U030057 Internal Control Module Software Incompatibility Invalid/Incompatible Software Component When the ignition switch is ON for 3 seconds, the vehicle information sent from the ECM does not match that stored in the forward recognition camera for approximately 1 second or more. Pre-collision system Radar Cruise2

PROCEDURE

1.CHECK PRE-COLLISION SYSTEM
a.

Check the pre-collision system.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>U030051

HINT:

If DTC U030051 or U030057 is output by the dynamic radar cruise control system, perform troubleshooting for the pre-collision system.



Result:
Proceed to
NEXT



NEXT

END