Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY › from 2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327018 FOG LIGHT ASSEMBLY A

LIGHTING (EXT)  FOG LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Applies only for when removing and installing or replacing the rear television camera assembly.

Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 81220 2.REMOVE FOG LIGHT ASSEMBLY

a.
E458900

Remove the 3 screws and fog light assembly.