Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2021.02
RM33A0E _59 Vehicle Exterior _065397 EXTERIOR PANELS / TRIM _0319662 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  DISASSEMBLY  


PROCEDURE

Hide 89341K 1.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89347B 2.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 89341L 3.REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89341K 4.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89347B 5.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 82114 6.REMOVE NO. 4 ENGINE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)

a.

for Bar Type Radiator Grille:

i.

Disengage the 7 clamps to remove the No. 4 engine room wire.

B607467



b.

for Mesh Type Radiator Grille:

i.

Disengage the 12 clamps to remove the No. 4 engine room wire.

B607468



Hide 88211B 7.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Pre-collision System)

Hide 52114A 8.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Bar Type Radiator Grille)

a.

w/ Bracket:

i.
B608146

Remove the 2 screws.


ii.
B608147C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 4 claws to remove the front bumper extension mounting bracket as shown in the illustration.



Hide 52114A 9.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Mesh Type Radiator Grille)

a.
B608149

Remove the 2 screws.


b.
B608150C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws and 4 guides to remove the front bumper extension mounting bracket as shown in the illustration.


Hide 52423A 10.REMOVE FRONT BUMPER PAD LH (for Bar Type Radiator Grille)

a.
B607479

Remove the front bumper pad LH.


Hide 52422A 11.REMOVE FRONT BUMPER PAD RH (for Bar Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 52423A 12.REMOVE FRONT BUMPER PAD LH (for Mesh Type Radiator Grille)

a.
B607480

Disengage the 2 claws and guide to remove the front bumper pad LH.


Hide 52422A 13.REMOVE FRONT BUMPER PAD RH (for Mesh Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 86790B 14.REMOVE FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Hide 85354 15.REMOVE HEADLIGHT WASHER COVER LH (w/ Headlight Cleaner System)

Hide 85353 16.REMOVE HEADLIGHT WASHER COVER RH (w/ Headlight Cleaner System)

HINT:

Use the same procedure as for the LH side.


Hide 85208A 17.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)

Hide 85207A 18.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:

Use the same procedure as for the LH side.


Hide 19.REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)

a.

Disengage the 7 clamps to remove the headlight cleaner hose.

B607507


Hide 52128B 20.REMOVE FRONT BUMPER HOLE COVER LH (for Bar Type Radiator Grille)

a.
B607475C01
2.531,2.854 2.365,2.854 false 2.167,2.781 2.49,3.031 0.323,0.25 10 false *a
*a Hook
V113147

Remove in this Direction


Disengage the 4 claws and 2 guides as shown in the illustration.


b.

Disengage the hook to remove the front bumper hole cover LH.


Hide 52128B 21.REMOVE FRONT BUMPER HOLE COVER LH (for Mesh Type Radiator Grille)

a.
B607477C01
2.896,0.427 2.646,0.427 false 2.927,0.365 3.177,0.552 0.25,0.188 10 false *a
*a Hook
V113147

Remove in this Direction


Disengage the 5 claws as shown in the illustration.


b.

Disengage the hook to remove the front bumper hole cover LH.


Hide 52127D 22.REMOVE FRONT BUMPER HOLE COVER RH (for Mesh Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 53395E 23.REMOVE HOOD TO FRONT END PANEL SEAL

a.
B607482

Disengage the 6 clips.


b.
B607483C01
0,0 0,0 false
V100155

Double-sided Tape


Separate the double-sided tape and disengage the guide to remove the hood to front end panel seal.


Hide 75310A 24.REMOVE RADIATOR GRILLE EMBLEM ASSEMBLY

a.
B596563

Remove the screw.


b.
B596564

Disengage the 4 claws and guide to remove the radiator grille emblem assembly.


Hide 25.REMOVE FRONT BUMPER UPPER RETAINER

HINT:

Use the same procedure for the RH side and LH side.


a.
B596565

Remove the screw.


b.

Disengage the 2 guides to remove the front bumper upper retainer.


Hide 52111F 26.REMOVE FRONT CENTER BUMPER BAR (for Bar Type Radiator Grille)

a.
B607484C01
1.042,0.188 1.354,0.344 0.313,0.156 10 false *a 0.646,0.24 0.958,0.396 0.313,0.156 10 false *b 2.563,0.063 2.875,0.219 0.313,0.156 10 false *a 1.448,0.115 1.76,0.271 0.313,0.156 10 false *b 2.208,0.052 2.521,0.208 0.313,0.156 10 false *b 2.885,0.063 3.198,0.219 0.313,0.156 10 false *b
*a Clip
*b Screw


Remove the 2 clips.


b.

Remove the 4 screws and front center bumper bar.


Hide 53101 27.REMOVE RADIATOR GRILLE SUB-ASSEMBLY (for Bar Type Radiator Grille)

a.
B607485

Remove the 2 screws.


b.
B607486

Disengage the 10 claws and guide to remove the radiator grille sub-assembly.


Hide 53101 28.REMOVE RADIATOR GRILLE SUB-ASSEMBLY (for Mesh Type Radiator Grille)

a.
B607487

Remove the 2 clips.


b.
B607488

Remove the 10 screws.


c.
B607489

Disengage the 8 claws to remove the radiator grille sub-assembly.


Hide 81220 29.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)

Hide 81210A 30.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:

Use the same procedure as for the LH side.


Hide 52713A 31.REMOVE FRONT BUMPER SIDE MOULDING LH (for Bar Type Radiator Grille)

a.
B607490

Remove the 5 screws.


b.
B607491

Disengage the 3 claws and 2 guides to remove the front bumper side moulding LH.


Hide 52712 32.REMOVE FRONT BUMPER SIDE MOULDING RH (for Bar Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 81482C 33.REMOVE FOG LIGHT COVER LH (for Mesh Type Radiator Grille)

a.
B607492

Remove the 4 clips.


b.
B607493

Remove the clip.


c.
B607494

Disengage the 6 claws to remove the fog light cover LH.


Hide 81481E 34.REMOVE FOG LIGHT COVER RH (for Mesh Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 53124D 35.REMOVE LOWER RADIATOR GRILLE MOULDING LH (for Mesh Type Radiator Grille)

a.
B607495

Remove the screw.


b.
B607496

Disengage the 8 claws and guide to remove the lower radiator grille moulding LH.


Hide 53123C 36.REMOVE LOWER RADIATOR GRILLE MOULDING RH (for Mesh Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 52534 37.REMOVE FRONT NO. 2 BUMPER RETAINER BRACKET (for Mesh Type Radiator Grille)

a.
B606197C06
0,0 0,0 false
V100155

Double-sided Tape


Disengage the claw and separate the double-sided tape to remove the front No. 2 bumper retainer bracket.


Hide 52533 38.REMOVE FRONT NO. 1 BUMPER RETAINER BRACKET (for Mesh Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 53122G 39.REMOVE LOWER CENTER RADIATOR GRILLE MOULDING (for Mesh Type Radiator Grille)

a.
B607497

Remove the screw.


b.

Disengage the 4 claws and guide to remove the lower center radiator grille moulding.

B607498


Hide 53102A 40.REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY (for Bar Type Radiator Grille)

a.
B607499

Remove the 4 screws.


b.

Disengage the 17 claws to remove the lower radiator grille sub-assembly.

B607500


Hide 52112C 41.REMOVE FRONT BUMPER EXTENSION (for Bar Type Radiator Grille)

a.

for GR Sport:

i.

Remove the front bumper extension.

B612016



Hide 53102A 42.REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY (for Mesh Type Radiator Grille)

a.
B607501

Remove the 4 screws.


b.

Disengage the 24 claws and 6 guides to remove the lower radiator grille sub-assembly.

B607502


Hide 52713A 43.REMOVE FRONT BUMPER SIDE MOULDING LH (for Mesh Type Radiator Grille)

a.
B604943

Remove the 2 clips.


b.
B604944

Disengage the 2 claws and 2 guides to remove the front bumper side moulding LH.


Hide 52712 44.REMOVE FRONT BUMPER SIDE MOULDING RH (for Mesh Type Radiator Grille)

HINT:

Use the same procedure as for the LH side.


Hide 47749F 45.REMOVE PIN HOLD CLIP

a.
B473199C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 4 claws to remove the 2 pin hold clips as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



Hide 53879H 46.REMOVE FRONT FENDER LINER RETAINER

a.
B473201C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the 2 front fender liner retainers as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



Hide 52611 47.REMOVE FRONT BUMPER ENERGY ABSORBER

a.
B489576C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 4 guides to remove the front bumper energy absorber as shown in the illustration.


Hide 52131A 48.REMOVE FRONT BUMPER REINFORCEMENT

a.

Remove the headlight assembly LH.

for LED Type Turn Signal Light:

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)>REMOVAL

for Bulb Type Turn Signal Light:

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light)>REMOVAL


b.

Remove the headlight assembly RH.

HINT:

Use the same procedure as for the LH side.



c.
B481986

Disengage the 4 clamps.


d.

Remove the 6 bolts and front bumper reinforcement.

B481987


Hide 52536 49.REMOVE FRONT BUMPER SIDE RETAINER LH

a.
B470415

Remove the bolt.


b.
B470416C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 clips to remove the front bumper side retainer LH as shown in the illustration.


Hide 52535 50.REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.