Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2021.02
RM33A0E _59 Vehicle Exterior _065397 EXTERIOR PANELS / TRIM _0319662 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

TARGET ADJUSTMENT(TRIANGLE TARGET):

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(TRIANGLE TARGET)

TARGET ADJUSTMENT(FLAT SURFACE TARGET):

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(FLAT SURFACE TARGET)

DRIVING ADJUSTMENT:

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

w/ Headlight Cleaner System:

i.

Connect the headlight cleaner hose.



b.

w/ Fog Light:

i.

Connect the connector.



c.
B607466C01
0,0 0,0 false
V113147

Install in this Direction


Move the front bumper assembly into position and engage the 2 guides and 2 claws as shown in the illustration.


d.

Install the 4 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


e.

Install the 2 clips.


f.

w/ TOYOTA Parking Assist-sensor System:

i.

Connect the connector.



g.

w/ Pre-collision System:

i.

Connect the connector.



h.
B607461C01
0,0 0,0 false
V113147

Install in this Direction


Engage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



i.

Install the 8 screws.


j.

Install the clip.

HINT:

Use the same procedure for the RH side and LH side.



k.
B610751C02
0,0 0,0 false
V113147

Install in this Direction


Engage the 2 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



l.

Install the front bumper assembly.


Hide 53295E 2.INSTALL COOL AIR INTAKE DUCT SEAL

a.
B596542C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Engage the guide as shown in the illustration.


b.

Install the cool air intake duct seal with the 5 clips.


Hide 3.ADD WASHER FLUID (w/ Headlight Cleaner System)

Hide 4.ADJUST HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)

HINT:

Perform this procedure only when replacement of the front bumper reinforcement is necessary.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)>ADJUSTMENT


Hide 5.ADJUST HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light)

HINT:

Perform this procedure only when replacement of the front bumper reinforcement is necessary.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light)>ADJUSTMENT


Hide 6.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

Hide 86790B 7.ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Hide 8.PERFORM CALIBRATION (w/ Parking Support Brake System)