This DTC is stored if the television camera controller and rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B | Open or short in steering angle sensor +B | ·
Harness or connector ·
Steering sensor |
Circumference Monitoring Camera Control Module |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B | Open or short in steering angle sensor +B | ·
Harness or connector ·
Steering sensor |
Rear Camera |
Since the panoramic view monitor system has functions that use the CAN communication system, first check that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the K71 steering sensor connector.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K71-6 (ESS) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K71-9 (IG1) - K71-6 (ESS) | Ignition switch ON | 11 to 14 V |
| K71-4 (BAT) - K71-6 (ESS) | Ignition switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG