| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C060B13 | Left Electric Parking Brake Actuator Control Circuit Open | ·
Diagnosis Condition: Electric parking brake not operating ·
Malfunction Status: The ECU power supply is normal but there is a malfunction in the electric parking brake actuator LH internal circuit (open). ·
Detection Time: Approximately 0.015 to 0.195 seconds (depending on each malfunction) |
·
Parking brake actuator assembly LH ·
No. 2 parking brake wire assembly ·
Wire harness or connector ·
Skid control ECU (brake actuator assembly) |
DTC stored | An electric parking brake system malfunction is displayed on the combination meter assembly. |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the vR2 and v1 No. 2 parking brake wire assembly connectors.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| *a | Front view of No. 2 Parking Brake Wire Assembly | *b | to wire harness connector |
| *c | to Parking Brake Actuator Assembly LH | - | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| vR2-2 - v1-2 (LE+) | Always | Below 1 Ω |
| vR2-2 - Other terminals | Always | 10 kΩ or higher |
| vR2-1 - v1-1 (LE-) | Always | Below 1 Ω |
| vR2-1 - Other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Make sure the No. 2 parking brake wire assembly is securely installed.
Disconnect the A34 skid control ECU (brake actuator assembly) connector.
Disconnect the v1 parking brake actuator assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A34-13 (MRL+) - v1-2 (LE+) | Always | Below 1 Ω |
| A34-12 (MRL-) - v1-1 (LE-) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the parking brake actuator assembly LH.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL
Inspect the parking brake actuator assembly LH.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for RHD)>REMOVAL
NG