| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1550 | DAB Tuner Malfunction | When any of the following conditions is met:
·
DAB tuner decoder malfunction ·
DAB tuner audio output section malfunction ·
DAB tuner decoder RF/IF malfunction ·
DAB tuner control communication error ·
DAB tuner OFDM error ·
DAB tuner memory error |
Radio and display receiver assembly |
| B158D | Video Signal Stoppage | The interval video signal of the radio and display receiver assembly is interrupted | Radio and display receiver assembly |
| B15A0 | LAN Master Malfunction | When either of the following conditions is met:
·
Bus malfunction ·
EEPROM error |
Radio and display receiver assembly |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Radio and display receiver assembly |
| B15B3 | Radio Tuner Malfunction | When any of the following conditions is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
Radio and display receiver assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio and display receiver assembly |
| B15F9 | UART Communication Malfunction(for A/C) | When either of the following conditions is met:
·
Open in UART communication line is detected during radio and display receiver assembly startup routine ·
Open in UART communication line is detected based on communication error |
Radio and display receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG