16031
1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
16361A
2.REMOVE V-RIBBED BELT
16604
3.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
Remove the bolt and No. 2 idler pulley sub-assembly.
16173
4.REMOVE WATER PUMP PULLEY
| *a | Protective Tape |
| *b | Hold |
| *c | Turn |
Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.
Remove the 4 bolts and water pump pulley.
16100
5.REMOVE ENGINE WATER PUMP ASSEMBLY
Remove the 15 bolts, engine water pump assembly and water pump gasket.