Home › Engine / Hybrid System › A25A-FKS (ENGINE CONTROL) › KNOCK SENSOR › from 2021.02
RM33A0E _51 Engine / Hybrid System _065341 A25A-FKS ENGINE CONTROL _0328601 KNOCK SENSOR A

A25A-FKS ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Replacement of knock control sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89615 2.REMOVE KNOCK CONTROL SENSOR

a.
A402377

Disconnect the knock control sensor connector.


b.

Remove the bolt and knock control sensor from the cylinder block sub-assembly.

NOTICE:

If the knock control sensor has been struck or dropped, replace it.