The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
12361A
3.REMOVE FRONT ENGINE MOUNTING INSULATOR
11363A
4.REMOVE FLYWHEEL HOUSING SIDE COVER
Disengage the claw as shown in the illustration to remove the flywheel housing side cover.
28100
5.REMOVE STARTER ASSEMBLY
Disconnect the starter assembly connector.
Open the terminal cap.
Remove the nut and disconnect the No. 2 engine wire from terminal 30.
Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.