The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension arm assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
58399D
2.REMOVE NO. 2 FLOOR UNDER COVER (w/ Cover)
for LH Side:
Click hereSuspension>REAR SUSPENSION>REAR STABILIZER BAR>REMOVAL
58398F
3.REMOVE NO. 1 FLOOR UNDER COVER (w/ Cover)
for RH Side:
Click hereSuspension>REAR SUSPENSION>REAR STABILIZER BAR>REMOVAL
89408C
4.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)
for LH Side:
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL
48840A
5.REMOVE REAR STABILIZER LINK ASSEMBLY
48231B
6.REMOVE REAR COIL SPRING
48258C
7.REMOVE REAR LOWER COIL SPRING INSULATOR
48740F
8.REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY
Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly.
Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.
48720A
9.REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY
Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.