Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR › from 2021.02
RM33A0E _58 Vehicle Interior _065387 HEATING / AIR CONDITIONING _0319113 AMBIENT TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Applies only for when removing and installing or replacing the rear television camera assembly.

Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*


Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 16691A 2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH

a.

w/o Air Cooled Transmission Oil Cooler:

i.
E363451

Disengage the 2 claws to remove the front radiator side air guide plate RH.



b.

w/ Air Cooled Transmission Oil Cooler:

i.
E387127

Disengage the 2 claws to remove the front radiator side air guide plate RH.



Hide 88790B 3.REMOVE THERMISTOR ASSEMBLY

a.

w/o Air Cooled Transmission Oil Cooler:

i.
E363452

Disengage the clamp.


ii.

Disconnect the connector to remove the thermistor assembly.



b.

w/ Air Cooled Transmission Oil Cooler:

i.
E387128

Disengage the clamp.


ii.

Disconnect the connector to remove the thermistor assembly.