The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during television camera controller removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL
86796
2.REMOVE PARKING ASSIST ECU COVER
Remove the 3 clips and parking assist ECU cover.
86792
3.REMOVE TELEVISION CAMERA CONTROLLER
Disconnect each connector.
Disengage the clamp.
Turn back the front floor carpet assembly and front floor mat as shown in the illustration.
Remove the bolt.
Disengage the 2 guides and remove the television camera controller as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |