The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL
for M20A-FKS:
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
74038A
4.REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY
5.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
74220
7.REMOVE FRONT ARMREST ASSEMBLY
81230
8.REMOVE COURTESY LIGHT ASSEMBLY
67602
9.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
10.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL
67832
11.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
75720
13.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
|
Protective Tape |
Apply protective tape around the front door belt moulding assembly as shown in the illustration.
| *a | Claw |
|
Rotate in this Direction |
Disengage the 5 claws as shown in the illustration.
| *a | Thin-bladed Screwdriver with its Tip Wrapped with Protective Tape |
|
Push in this Direction |
Using a thin-bladed screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration.
Slightly twist and hold the front door belt moulding assembly in the direction indicated by the arrow (1) shown in the illustration.
|
Twist in this Direction (1) |
|
Slide in this Direction (2) |
If the front door belt moulding assembly is pulled upwards, the claw may break and fall inside the door panel.
Slide the front door belt moulding assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the claw and remove the front door belt moulding assembly.