When the mirror heater switch (rear window defogger switch) is operated, the mirror heater signal is sent to the air conditioning amplifier assembly via LIN communication and then to each outer mirror control ECU assembly via CAN communication. Based on this signal, the outer mirror control ECU assemblies operate the mirror heaters.
The power mirror control system (w/ Memory) uses the CAN communication system and LIN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power mirror control system (w/ Memory) after confirming that the communication systems are functioning properly.
If the battery voltage is low, the mirror heater function may not operate.
Check window defogger system operation.
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>OPERATION CHECK
Window defogger system is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Mirror L or Mirror R / Active Test.
Perform an Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Mirror Heater | Mirror heater operation | OFF or ON | ·
Operate with the engine switch on (IG) and the vehicle stopped. ·
This test turns the mirror heater on or off. ·
Mirror heater operation can be confirmed by touch. |
| Tester Display |
|---|
| Mirror Heater |
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Mirror Heater | Mirror heater operation | OFF or ON | ·
Operate with the engine switch on (IG) and the vehicle stopped. ·
This test turns the mirror heater on or off. ·
Mirror heater operation can be confirmed by touch. |
| Tester Display |
|---|
| Mirror Heater |
| Result | Proceed to |
|---|---|
| Mirror heater operation on both mirrors is normal | A |
| Mirror heater operation on driver door mirror is not normal | B |
| Mirror heater operation on front passenger door mirror is not normal | C |
A
B
C
Disconnect the O9 outer mirror control ECU assembly (driver door) connector.
Disconnect the O21*1 or O22*2 outer rear view mirror assembly (driver door) connector.
*1: for 16 Pin Connector
*2: for 22 Pin Connector
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O9-4 (HTR+) - O21-7 (+) | Always | Below 1 Ω |
| O9-12 (HTR-) - O21-15 (-) | Always | Below 1 Ω |
| O9-4 (HTR+) or O21-7 (+) - Body ground | Always | 10 kΩ or higher |
| O9-12 (HTR-) or O21-15 (-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O9-4 (HTR+) - O22-6 (+) | Always | Below 1 Ω |
| O9-12 (HTR-) - O22-17 (-) | Always | Below 1 Ω |
| O9-4 (HTR+) or O22-6 (+) - Body ground | Always | 10 kΩ or higher |
| O9-12 (HTR-) or O22-17 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer mirror (driver door).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>REMOVAL
Inspect the outer mirror (driver door).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer rear view mirror assembly (driver door).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL
Inspect the outer rear view mirror assembly (driver door) (mirror heater).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N10 outer mirror control ECU assembly (front passenger door) connector.
Disconnect the N23*1 or N24*2 outer rear view mirror assembly (front passenger door) connector.
*1: for 16 Pin Connector
*2: for 22 Pin Connector
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N10-4 (HTR+) - N23-7 (+) | Always | Below 1 Ω |
| N10-12 (HTR-) - N23-15 (-) | Always | Below 1 Ω |
| N10-4 (HTR+) or N23-7 (+) - Body ground | Always | 10 kΩ or higher |
| N10-12 (HTR-) or N23-15 (-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N10-4 (HTR+) - N24-6 (+) | Always | Below 1 Ω |
| N10-12 (HTR-) - N24-17 (-) | Always | Below 1 Ω |
| N10-4 (HTR+) or N24-6 (+) - Body ground | Always | 10 kΩ or higher |
| N10-12 (HTR-) or N24-17 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer mirror (front passenger door).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>REMOVAL
Inspect the outer mirror (front passenger door).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer rear view mirror assembly (front passenger door).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL
Inspect the outer rear view mirror assembly (front passenger door) (mirror heater).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG