The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear sunshade assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
2.REMOVE REAR SEAT ASSEMBLY (for Reclining Seat Type)
81006
3.REMOVE CENTER STOP LIGHT SET
73370E
4.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
73360D
5.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62472A
6.REMOVE INNER ROOF SIDE GARNISH LH
62471A
7.REMOVE INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
73373F
8.REMOVE REAR SEAT SHOULDER BELT HOLE COVER
64330
9.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64272B
10.REMOVE ROOM PARTITION BOARD LH (for Fold Down Seat Type)
64271G
11.REMOVE ROOM PARTITION BOARD RH (for Fold Down Seat Type)
64165B
12.REMOVE NO. 1 UPPER BACK PANEL HOLE COVER
Remove the No. 1 upper back panel hole cover.
64340B
13.REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY
|
Remove in this Direction |
Disengage the 3 clips as shown in the illustration.
|
Remove in this Direction |
Disengage the 5 guides to remove the No. 2 package tray trim panel assembly as shown in the illustration.
64350A
14.REMOVE REAR WINDOW SHADE ASSEMBLY
Disconnect the connector.
Remove the 3 bolts (A).
Loosen the bolt (B) and remove the rear window shade assembly.
Bolt (B) cannot be removed from the rear window shade assembly.