Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(for RHD)
RM33C0E _54 Brake _065442 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0319338 BRAKE ACTUATOR(for RHD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(for RHD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The parking brake indicator light blinks (red) when the power switch is turned on after replacing the brake actuator assembly. Operate the electric parking brake switch assembly to turn off the parking brake indicator light.


PROCEDURE

Hide 44546A 1.INSTALL BRAKE ACTUATOR BOLT CUSHION

a.

Install the 3 brake actuator bolt cushions to the brake actuator bracket assembly.


b.

Install the 3 brake actuator case collars to the brake actuator bolt cushions.

NOTICE:

Make sure that the brake actuator case collars are in full contact with the brake actuator bolt cushions.



Hide 44510 2.INSTALL BRAKE ACTUATOR ASSEMBLY

a.

Install the brake actuator assembly to the brake actuator bracket assembly with the 3 bolts.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

NOTICE:
·

Do not remove the hole plugs of a new brake actuator assembly before connecting the brake lines because the brake actuator assembly is filled with brake fluid.

·

Do not hold the brake actuator assembly by the connector.

·

Do not drop the brake actuator assembly when carrying it.




Hide 47070 3.INSTALL BRAKE BOOSTER PUMP ASSEMBLY