Home › Drivetrain › P710 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE SYSTEM
RM33C0E _52 Drivetrain _065428 P710 HYBRID TRANSMISSION / TRANSAXLE _0319549 HYBRID TRANSAXLE SYSTEM G

P710 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A345137

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the power switch on (IG).


PROCEDURE

Hide 53737B 1.REMOVE FRONT FENDER APRON SEAL LH

Hide 2.INSPECT TRANSAXLE FLUID PRESSURE

NOTICE:

Make sure to perform the following inspection after inspecting and adjusting the engine.


a.
C381251

Remove the transmission oil pump cover plug from the hybrid vehicle transaxle assembly.


b.

Remove the O-ring from the transmission oil pump cover plug.


c.
C381252C02
2.323,0.406 2.719,0.406 2.719,0.406 2.719,0.76 false 2.5,0.771 2.5,0.406 false 2.906,0.813 2.969,0.625 2.969,0.625 3.083,0.625 false 1.656,1.896 2.125,1.896 true 2.167,0.333 2.448,0.563 0.281,0.229 10 false *1 3.135,0.531 3.354,0.729 0.219,0.198 10 false *2 2.146,1.813 2.5,2.021 0.354,0.208 10 true SST
*1 Gasket
*2 O-ring


Install SST to the hybrid vehicle transaxle assembly.

SST
09993-19015  (09993-00020, 09993-00040)


d.

Put the engine in Inspection Mode (Maintenance Mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.

Measure the hybrid transaxle fluid pressure.

Reference:
Maintenance Mode Engine Idle Speed Hybrid Transaxle Fluid Temperature Hybrid Transaxle Fluid Pressure
900 to 1000 rpm 20 to 50°C (68 to 122°F) 9.8 kPa (0.1 kgf/cm2, 1 psi) or more


NOTICE:

Be sure to cancel maintenance mode immediately after the hybrid transaxle fluid pressure check is completed.



f.

Remove SST from the hybrid vehicle transaxle assembly.


g.

Coat a new O-ring with ATF and install it to transmission oil pump cover plug.


h.

Install the transmission oil pump cover plug to the hybrid vehicle transaxle assembly.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 53737B 3.INSTALL FRONT FENDER APRON SEAL LH