Home › Drivetrain › P710 (HYBRID TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › 2017.09–2019.10
RM33C0E _52 Drivetrain _065428 P710 HYBRID TRANSMISSION / TRANSAXLE _0319558 TRANSMISSION CONTROL CABLE A

P710 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 53295E 2.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 5.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 58152A 7.REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR

a.
C377864

Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.


Hide 8.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

Hide 58861B 9.REMOVE NO. 1 CONSOLE BOX DUCT

a.
C370854

Remove the No. 1 console box duct.


Hide 82111 10.DISCONNECT ENGINE ROOM MAIN WIRE

Hide 33820B 11.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C377868

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.
C377869

Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with the clip from the No. 1 transmission control cable bracket.


d.
C377870

Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.


e.
C377867

Remove the 3 bolts and disconnect the transmission control cable assembly from the inverter with converter assembly.


f.
C377871

Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.


g.
C377872

Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.