77651A
1.INSTALL NO. 1 FUEL TANK CUSHION
Install 2 new No. 1 fuel tank cushions to the fuel tank assembly.
77754B
2.INSTALL CHARCOAL CANISTER OUTLET HOSE
Engage the clamp to install the charcoal canister outlet hose to the fuel tank assembly.
77209F
3.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Engage the 2 clamps to install the fuel tank main tube sub-assembly to the fuel tank assembly.
77100
4.INSTALL FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then install the fuel tank assembly, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH with the 4 bolts in the order shown in the illustration.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77213E
5.CONNECT FUEL TANK TO FILLER PIPE HOSE
| *a | Up |
| *b | 120° |
| *c | 10° |
| *d | 0 to 3.0 mm (0 to 0.118 in.) |
| *e | Clamp End |
| *f | Stopper |
| *g | +/- 2.0 mm (0.0787 in.) |
Connect the fuel tank to filler pipe hose to the fuel tank assembly and tighten the clamp to secure it.
Make sure the clamp and fuel tank to filler pipe hose are positioned within the area shown in the illustration.
Make sure that the clamp end is positioned within 2.0 mm (0.0787 in.) of the stopper.
6.CONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY
| *a | Up |
| *b | 120° |
| *c | 0 to 3.0 mm (0 to 0.118 in.) |
| *d | 2.0 to 7.0 mm (0.0787 to 0.276 in.) |
Connect the fuel tank breather tube sub-assembly to the fuel tank filler pipe assembly and tighten the clamp to secure it.
Make sure the clamp and fuel tank breather tube sub-assembly are positioned within the area shown in the illustration.
77754B
7.CONNECT CHARCOAL CANISTER OUTLET HOSE
Connect the charcoal canister outlet hose to the fuel tank filler pipe assembly.
77209F
8.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>A25A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION
77641A
9.INSTALL NO. 1 FUEL TANK PROTECTOR
Install the No. 1 fuel tank protector to the fuel tank assembly with the 3 clips.
58399D
10.INSTALL NO. 2 FLOOR UNDER COVER (w/ Cover)
17420
11.INSTALL CENTER EXHAUST PIPE ASSEMBLY
77020A
12.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
13.ADD FUEL