Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › CANISTER (w/o Canister Pump Module) › 2017.09–2019.02
RM33C0E _51 Engine / Hybrid System _065422 A25A-FXS EMISSION CONTROL _0322968 CANISTER(w/o Canister Pump Module) A

A25A-FXS EMISSION CONTROL  CANISTER(w/o Canister Pump Module)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during canister (fuel suction plate sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Replacement of fuel pump Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)