Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › THROTTLE BODY
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0326944 THROTTLE BODY A

A25A-FXS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53295E 3.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 4.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

a.
A406006

Disconnect the mass air flow meter sub-assembly connector.


b.

Disengage the wire harness clamp.


c.
A406007C01
2.396,0.906 2.646,1.094 0.25,0.188 10 true *a 2.458,2.802 2.719,2.99 0.26,0.188 10 true *b 2.865,0.906 3.115,1.094 0.25,0.188 10 true *a 3.01,2.813 3.271,3 0.26,0.188 10 true *b
*a Air Cleaner Cap Clamp
*b Guide


Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.


d.

Disengage the 2 air cleaner cap clamps.


e.

Disengage the 2 guides to separate the air cleaner cap sub-assembly from the air cleaner case sub-assembly.


f.

Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.


Hide 22030 6.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A406010

Disconnect the throttle body with motor assembly connector.


b.

Slide the clip and disconnect the No. 5 water by-pass hose from the throttle body with motor assembly.


c.

Using an 8 mm socket wrench, remove the 3 bolts and separate the throttle body with motor assembly from the intake manifold.


d.
A406012

Slide the clip and disconnect the No. 6 water by-pass hose to remove the throttle body with motor assembly.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 7.REMOVE THROTTLE BODY GASKET

a.
A406014

Remove the throttle body gasket from the intake manifold.