The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) or frame number registration when replacing the ECM.
w/ Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>REGISTRATION
w/o Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>REGISTRATION
64718C
1.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
89661
3.REMOVE ECM
for LHD:
Rotate the 2 levers while pushing the locks, and disconnect the 2 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the bolt and separate the engine wire from the No. 2 ECM bracket.
Disengage the clamp.
Remove the 2 nuts and ECM.
If the ECM has been struck or dropped, replace it.
for RHD:
Rotate the 2 levers while pushing the locks, and disconnect the 2 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the bolt and separate the engine wire from the No. 2 ECM bracket.
Disengage the 2 clamps.
Remove the 2 nuts and ECM.
If the ECM has been struck or dropped, replace it.
89667E
4.REMOVE NO. 1 ECM BRACKET
| *A | for LHD |
| *B | for RHD |
Remove the 2 screws and No. 1 ECM bracket from the ECM.
89668
5.REMOVE NO. 2 ECM BRACKET
| *A | for LHD |
| *B | for RHD |
Remove the 2 screws and No. 2 ECM bracket from the ECM.