The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
17111
1.REMOVE INTAKE MANIFOLD
89615
2.REMOVE KNOCK CONTROL SENSOR
Disconnect the knock control sensor connector.
Remove the bolt and knock control sensor from the cylinder block sub-assembly.
If the knock control sensor has been struck or dropped, replace it.