The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
22030
1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
25620
2.REMOVE EGR VALVE ASSEMBLY
89421
3.REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
25860
4.REMOVE PURGE VALVE (PURGE VSV)
82121
5.DISCONNECT ENGINE WIRE
Disconnect the No. 5 engine wire connector.
Remove the bolt and disconnect the engine wire from the cylinder head sub-assembly.
Remove the bolt.
Disengage the wire harness clamp and disconnect the engine wire from the intake manifold.
16279
6.DISCONNECT NO. 3 WATER BY-PASS PIPE
Slide the clip and disconnect the No. 5 water by-pass hose from the No. 3 water by-pass pipe.
Using an 8 mm socket wrench, remove the bolt and disconnect the No. 3 water by-pass pipe from the intake manifold.
16278
7.REMOVE NO. 2 WATER BY-PASS PIPE
Disengage the wire harness clamp and disconnect the HV air conditioning wire.
Using an 8 mm socket wrench, remove the 2 bolts (A) and separate the No. 2 water by-pass pipe from the intake manifold.
Remove the bolt (B) and No. 2 water by-pass pipe from the cylinder block sub-assembly.
23820
8.REMOVE NO. 2 FUEL VAPOR FEED HOSE
Remove the No. 2 fuel vapor feed hose from the intake manifold.
17111
9.REMOVE INTAKE MANIFOLD
w/o Stud Bolt:
Remove the 5 bolts and intake manifold from the cylinder head sub-assembly.
w/ Stud Bolt:
Remove the 3 bolts and 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and intake manifold from the cylinder head sub-assembly.
17177
10.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
Remove the No. 1 intake manifold to head gasket from the intake manifold.
12611B
11.REMOVE NO. 1 ENGINE COVER
Remove the clip and No. 1 engine cover.
12.REMOVE VACUUM HOSE
Remove the vacuum hose from the intake manifold.