Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM33C0E _54 Brake _065442 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0328411 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C147D  Air Bag Circuit  


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) receives the secondary collision brake control request signal from the airbag sensor assembly.

DTC No. Detection Item INF Code DTC Detection Condition Trouble Area Note
C147D Air Bag Circuit 451 An abnormal secondary collision brake control request signal is received 2 times or more when communication with the airbag sensor assembly is possible.
·

Airbag sensor assembly

·

Skid control ECU (brake booster with master cylinder assembly)


Secondary collision brake DTC
HINT:

The DTC is cleared when the conditions return to normal.



CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION


PROCEDURE

1.CHECK DTC (AIRBAG SYSTEM)
a.

Check if airbag system DTCs are output.

Body Electrical > SRS Airbag > Trouble Codes
50001 188

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

B