Home › Engine / Hybrid System › A25A-FXS (COOLING) › THERMOSTAT › 2017.09–2020.08
RM33C0E _51 Engine / Hybrid System _065424 A25A-FXS COOLING _0328475 THERMOSTAT A

A25A-FXS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide 16572D 2.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16031 3.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A406300

Disconnect the water inlet with thermostat sub-assembly connector.


b.
A406301

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.



HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.



c.
A406302

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


d.
A402018

Remove the gasket from the water inlet with thermostat sub-assembly.