Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY VOLTAGE SENSOR
RM33C0E _51 Engine / Hybrid System _065433 HYBRID / BATTERY CONTROL _0328988 BATTERY VOLTAGE SENSOR A

HYBRID / BATTERY CONTROL  BATTERY VOLTAGE SENSOR  INSTALLATION  


PROCEDURE

Hide 89892A 1.INSTALL BATTERY VOLTAGE SENSOR

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.
A406063C01
0.885,2.781 1.688,2.781 true 1.438,1.167 1.833,1.938 1.833,1.938 2.073,1.938 true 2.115,1.833 2.427,1.99 0.313,0.156 10 false *a 1.719,2.698 2.031,2.854 0.313,0.156 10 false *b
*a Blue Label
*b Pin


Install the battery voltage sensor to the HV battery with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

Check color of the label.

·

If the battery voltage sensor has been struck or dropped, replace it.

·

Make sure to align the hole of the battery voltage sensor with the pin.




b.

Connect the battery voltage sensor connector.

NOTICE:

Make sure that the connector is connected securely.



Hide G92Q1 2.INSTALL NO. 1 HV BATTERY SHIELD PANEL

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Pull back the rear No. 1 HV battery shield and install the No. 1 HV battery shield panel to the HV battery.


b.

Install the bolt and nut.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


c.

Connect the battery voltage sensor connector.


d.

Engage the clamp.


Hide G920NB 3.INSTALL UPPER HV BATTERY COVER SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the upper HV battery cover sub-assembly to the HV battery with the 8 bolts and 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)