Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR
RM33C0E _51 Engine / Hybrid System _065433 HYBRID / BATTERY CONTROL _0328991 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide 53852K 1.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851M 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide G9040 5.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A406122

Disconnect the inverter water pump assembly connector.

NOTICE:
To prevent coolant from entering the inverter water pump assembly connector, perform the following procedure.

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly.



b.

Remove the 2 bolts to remove the inverter water pump assembly from the fan shroud assembly.


c.
A406123C02
0.969,0.354 1.354,0.354 true 0.5,0.854 0.708,0.854 0.708,0.854 0.813,1.073 true 0.792,0.271 0.979,0.469 0.188,0.198 10 true *1 0.313,0.75 0.5,0.948 0.188,0.198 10 true *2
*1 No. 2 Inverter Cooling Hose
*2 No. 3 Inverter Cooling Hose


Slide the 2 clips and disconnect the No. 2 inverter cooling hose and No. 3 inverter cooling hose to remove the inverter water pump assembly.

NOTICE:
·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.