Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2017.09–2021.02
RM33C0E _54 Brake _065446 PARKING BRAKE _0329402 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  C13A0  Open Circuit in Power Source Circuit  C13A5  Electric Current of Motor  C13B0  Electric Parking Brake ECU Malfunction  


DESCRIPTION

The following DTCs are stored when a malfunction occurs in the parking brake ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C13A0 Open Circuit in Power Source Circuit Both of following conditions are met:
1.

Power switch on (IG) or electric parking brake switch (electric parking brake switch assembly) pulled to lock side with power switch off.

2.

Parking brake ECU (brake actuator assembly) power source relay circuit is open for approximately 0.5 seconds.


Parking brake ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C13A5 Electric Current of Motor Both of following conditions are met:
1.

Power switch on (IG) or electric parking brake switch (electric parking brake switch assembly) pulled to lock side with power switch off.

2.

Parking brake ECU (brake actuator assembly) internal current is abnormal for approximately 0.1 to 0.5 seconds (differs according to malfunction).


Parking brake ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C13B0 Electric Parking Brake ECU Malfunction Both of following conditions are met:
1.

Power switch on (IG) or electric parking brake switch (electric parking brake switch assembly) pulled to lock side with power switch off.

2.

Internal current of Parking brake ECU (brake actuator assembly) or ECU components abnormal for a maximum of 60 seconds (differs according to malfunction).


Parking brake ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

DTC Detection Conditions: C13A0
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Power switch on (IG) ○ -
Electric parking brake switch (electric parking brake switch assembly) pulled to lock side with power switch off - ○
Malfunction Status Parking brake ECU (brake actuator assembly)'s power source relay is open ○ ○
Detection Time Approximately 0.5 seconds Approximately 0.5 seconds
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


DTC Detection Conditions: C13A5
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4
Diagnosis Condition Power switch on (IG) ○ - ○ -
Electric parking brake switch (electric parking brake switch assembly) pulled to lock side with power switch off - ○ - ○
Malfunction Status Parking brake ECU (brake actuator assembly)'s internal current is abnormal (When parking brake is operating) ○ ○ - -
Parking brake ECU (brake actuator assembly)'s internal current is abnormal (When parking brake is not operating) - - ○ ○
Detection Time Approximately 0.3 seconds Approximately 0.3 seconds Approximately 0.5 seconds Approximately 0.5 seconds
Number of Trips 1 trip 1 trip 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


DTC Detection Conditions: C13B0
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4
Diagnosis Condition Power switch on (IG) ○ - ○ -
Electric parking brake switch (electric parking brake switch assembly) pulled to lock side with power switch off - ○ - ○
Malfunction Status Parking brake ECU (brake actuator assembly)'s internal voltage is abnormal ○ ○ - -
EEPROM is malfunctioning - - ○ ○
Detection Time Approximately 0.5 seconds Approximately 0.5 seconds Approximately 0.5 seconds Approximately 0.5 seconds
Number of Trips 1 trip 1 trip 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

The parking brake indicator light blinks (red) when the power switch is turned on (IG) after replacing the parking brake ECU (brake actuator assembly). Operate the electric parking brake switch (electric parking brake switch assembly) to turn off the parking brake indicator light (red).


PROCEDURE

1.REPLACE PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY)
a.

Replace the parking brake ECU (brake actuator assembly).

for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for LHD)>REMOVAL

for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for RHD)>REMOVAL

Result:
Proceed to
NEXT




NEXT

END