| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13AE | System information not received | Both of following conditions are met:
1.
Power switch on (IG) 2.
When power switch is first turned on (IG) after parking brake ECU (brake actuator assembly) has been replaced, system cannot communicate with hybrid vehicle control ECU assembly for approximately 4 seconds |
·
Hybrid vehicle control ECU assembly ·
CAN communication system ·
Parking brake ECU (brake actuator assembly) |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
The parking brake indicator light blinks (red) when the power switch is turned on (IG) after replacing the parking brake ECU (brake actuator assembly). Operate the electric parking brake switch (electric parking brake switch assembly) to turn off the parking brake indicator light (red).
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Check for DTC.
| Result | Proceed to |
|---|---|
| DTC C13AE and a CAN DTC are output at the same time | A |
| DTC C13AE is output and the MIL is illuminated | B |
| Only DTC C13AE is output | C |
| DTCs are not output | D |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for RHD)>REMOVAL
D
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING