Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2017.09–2017.12
RM33C0E _58 Vehicle Interior _065457 LIGHTING (INT) _0330219 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ACC SW Power switch on (ACC) signal OFF or ON OFF: Power switch off
ON: Power switch on (ACC)
"ON" is also displayed for this item when the power switch is on (IG).
IG SW Power switch on (IG) signal OFF or ON OFF: Power switch off
ON: Power switch on (IG)
"OFF" is also displayed for this item when the power switch is on (ACC).
RR Door Courtesy SW Rear door courtesy light switch assembly RH signal OFF or ON OFF: Rear door RH closed
ON: Rear door RH open
-
RL Door Courtesy SW Rear door courtesy light switch assembly LH signal OFF or ON OFF: Rear door LH closed
ON: Rear door LH open
-
FR Door Lock Pos Front door RH unlock detection switch signal LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy SW Front door courtesy light switch assembly RH signal OFF or ON OFF: Front door RH closed
ON: Front door RH open
-
FL Door Lock Pos Front door LH unlock detection switch signal LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy SW Front door courtesy light switch assembly LH signal OFF or ON OFF: Front door LH closed
ON: Front door LH open
-
RR-Door Lock Pos SW Rear door RH unlock detection switch signal OFF or ON OFF: Rear door RH locked
ON: Rear door RH unlocked
-
RL-Door Lock Pos SW Rear door LH unlock detection switch signal OFF or ON OFF: Rear door LH locked
ON: Rear door LH unlocked
-
Luggage Courtesy SW Luggage compartment door courtesy switch signal OFF or ON OFF: Luggage compartment door closed
ON: Luggage compartment door open
-
Interior Light Control Operation of the illuminated entry system OFF or ON Customized value is displayed -
I/L ON W/Door Key Unlock Function that turns on the interior lights when the doors are unlocked OFF or ON Customized value is displayed -
Lighting Time Lighting time of the delay control function (illuminated entry system) 15 s, 7.5 s or 30 s Customized value is displayed -
Room Light when Aprchd Function that turns on the interior lights when a key enters any actuation area OFF or ON Customized value is displayed -
Inside Foot Light Function that turns on the footwell light (No. 1 interior illumination light assembly) OFF or ON Customized value is displayed -
I/L when ACC OFF Function that turns on the interior lights when the power switch is turned from on (ACC) or on (IG) to off OFF or ON Customized value is displayed -
Light Control Function that dims the following lights when the power switch is on (IG) and the shift lever is moved to any position other than P:
·

Footwell light (No. 1 interior illumination light assembly)

·

Front door inside handle illumination light (No. 1 interior illumination light assembly)

·

Rear door inside handle illumination light (No. 2 interior illumination light assembly)*1

·

Instrument panel ambient illumination light (Instrument panel light assembly)*2


OFF or ON Customized value is displayed -
Interior Illumination Light Function that turns on the following lights:
·

Front door inside handle illumination light (No. 1 interior illumination light assembly)

·

Rear door inside handle illumination light (No. 2 interior illumination light assembly)*1

·

Instrument panel ambient illumination light (Instrument panel light assembly)*2


OFF or ON Customized value is displayed -

*1: w/ Rear Door Inside Handle Illumination Light

*2: w/ Instrument Panel Ambient Illumination Light




ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / (desired system) / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Illuminated Entry System Turns on the lights that are controlled by the illuminated entry system*1 OFF or ON Perform the Active Test with the door linked switch of the map light (roof console box sub-assembly) on and switches of the spot light assembly LH and RH off.
Fr Foot Light Footwell light (No. 1 interior illumination light assembly) OFF or ON Preconditions for using the Active Test to check dimmer controlled illumination:
·

Power switch on (IG)

·

Shift lever is in any position other than P


Relay for Interior Light Auto Cut Function DOME CUT relay OFF or ON When performing this Active Test, turn all the interior lights on.
·

OFF: DOME CUT relay on (interior lights turn on)

·

ON: DOME CUT relay off (interior lights turn off)


Interior Illumination Light1 Instrument panel ambient illumination light (Instrument panel light assembly)*2 OFF or ON Preconditions for using the Active Test to check dimmer controlled illumination:
·

Power switch on (IG)

·

Shift lever is in any position other than P


Interior Illumination Light2
·

Front door inside handle illumination light (No. 1 interior illumination light assembly)

·

Rear door inside handle illumination light (No. 2 interior illumination light assembly)*3


OFF or ON Preconditions for using the Active Test to check dimmer controlled illumination:
·

Power switch on (IG)

·

Shift lever is in any position other than P


*1: Refer to System Description for the lights that are controlled by the illuminated entry system.

Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>SYSTEM DESCRIPTION

*2: w/ Instrument Panel Ambient Illumination Light

*3: w/ Rear Door Inside Handle Illumination Light


Body Electrical > Entry&Start > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Power/Engine SW Light Power switch illumination OFF or ON -